RPM Steering TJ to JK Axle conversion 1 Ton Aluminum Tie Rod and Drag Link Stock Location Under Knuckle Standard Stabilizer Clamp - RPM-1015SC

Jeep Wrangler TJ to JK Axle conversion 1-Ton Aluminum Tie Rod and Drag link(Stock Location/under knuckle). This kit is made specifically to put a JK axle under your TJ/LJ.

Our drag link bolts right up to the factory pitman arm. This kit requires no drilling. The factory JK tie rod is made from a hollow thin-wall tube.

The problem with most aftermarket units is they are still made of steel which once bent will stay bent. Our tie rod and drag link are made with 1.5 inch Solid 7075 aircraft aluminum.

7075 aluminum carries a memory to it. When it is bent, it pops back into place!

Never replace your tie rod again!!!

Features:

• Standard Stabilizer Clamp
• 7075 center section with Limited Lifetime Warranty
• Hexed ends for easy adjustment
• Right and left hand threaded offset 1-ton tie rod ends for one-handed adjustment on toe settings
• Greaseable 1-ton tie rod ends

Please Note:

• AEV or stock Rubicon wheels require a 1.5 inch wheel spacer
• 17 inch wheel with a 4.75 inch backspacing or less required
• If running 4 inch+ height springs, we recommend our flip kit